hitachi — Exhaust gas contains a lot of white smoke.

1E-558 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 6 Check the injector. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Start the engine. 3. Select the “Actuator test” from the scan tool menu. 4. Select the “Injection stop at each injector” in the “Common rail system”. 5. Press the “OFF” soft key to stop the fuel injection in the cylinder one by one, and check the change in engine sound. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 9. Go to Step 7.

7 Perform the pre-injection stop test. Select the “Stop pre-injection” from the scan tool menu to perform the test. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 9. Go to Step 10. 8 Check the injector using injector checker. Refer to “How to use injector checker” in this section for how to use injector checker. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 9. Go to Step 10. 9 Replace the injector in the cylinder of which engine sound did not change when it is stopped. Note: For work procedure, refer to “Engine section” in the service manual.

Is the procedure completed? — Go to Step 10. — 10 Check the coupling of the supply pump for damage. If the trouble is detected, repair as required. Is the procedure completed? — Go to Step 11. — 11 Check for the engine symptom again. Is the engine symptom corrected? — Go to Step 17. Go to Step 12. 12 Is EMPS available? — Go to Step 13. Go to Step 14.