Electronic control fuel injection system (Common rail type) 1E-565 Fuel consumption deteriorates. Pre-inspection Wire is connected, tightened or cut properly. ECM ground is not contaminated and installed to the proper position securely. Pipes and hoses relevant to fuel, air and oil are free of crack or twist, and are properly connected. Thoroughly check for any oil leakage and clogging. Fuel system is free from oil leakage, and pipe is not damaged or dent. Intake system parts for fault. Exhaust system parts for fault. Before using this paragraph, perform the “OBD system check” and check all the following items. Fuel consumption varies depending on handling of each machine.
Check Hitachi Construction Machinery's measure of fuel consumption (A). Measure of fuel consumption ( 2 {qts}/hour) Check the actual fuel consumption (B). Actual fuel consumption ( 2 {qts}/hour) If B is bigger than A, check the machine’s setting by referring to the machine’s manual. Check if excessive load is applied to the machine. Refer to the list of inspection and maintenance items of the operation manual for proper inspection depending on the operation time. If the operation time exceeds 3000 hours, inspect by referring to the machine’s manual. ECM and diagnosis lamp operate properly. Check the DTC.
Check the condition of the machine to identify the applicable symptom from “List of trouble symptom”. Perform the procedure described in the symptom chart. Check with the customer if correct engine oil and fuel are used. Check if periodic maintenance has been performed for engine oil replacement, air cleaner filter, fuel filter, etc.
Diagnostic aid Fuel system fault (run out of fuel, frozen fuel, air mixed in fuel pipe, faulty filter [clog in main filter, gauze filter], pipe fault, fuel quality, fuel tank [foreign matter, fuel suction fault]) Intake system fault (EGR valve fault) Injector fault (excessive fuel injection etc.) Engine body fault (seizure, compression pressure shortage, other mechanical trouble) Machine side related equipment trouble (oil pressure pump etc.) ECM trouble (body, power supply, ground, etc.) Check the connector for poor contact, the harness for fault such as wear or bend, and the wire inside the harness for loosened wire causing short circuit to other circuits.
Also, perform the function diagnosis to check the operation and control of each part. Repair if faulty. Visual check Careful visual check is required for some symptom procedures. By this inspection, the problem can be corrected without performing further inspection, and time can be saved. This inspection includes the following items. Step Action Value YES NO 1 1. Compare the measure of fuel consumption with the actual fuel consumption. A: Measure of fuel consumption (2{qts}/ hour) B: Actual fuel consumption (2{qts}/hour) 2. If B is bigger than A, check the machine’s setting or if excessive load is applied to the machine by referring to the machine’s manual. 3.
Repair or replace the faulty part. Is the procedure completed? — Verify repair. Go to Step 2. 2 Check for fuel leakage. Repair or replace the faulty part. Is the procedure completed? — Verify repair. Go to Step 3.