hitachi — Fuel consumption deteriorates.

1E-566 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 3 Check if periodic maintenance has been performed for engine oil replacement, air cleaner filter, fuel filter, etc. Is the procedure completed? — Perform maintenance for the machine. Go to Step 4. 4 Check the intake system and intercooler for water accumulation. Is the procedure completed? — Go to Step 5. Go to “Intake system check”. 5 Check the exhaust system for crush, bent or clogging. Is the procedure completed? — Go to Step 6. Go to “Exhaust system check”. 6 Check for output shortage. Is the procedure completed? — Go to Step 7. Go to “Output shortage, lag down”. 7 1.

Check the coupling of the supply pump for damage. 2. Check the coupling of the supply pump for worn out of alignment mark. Repair or replace the faulty part. Is the procedure completed? — Go to Step 8. — 8 Check if the engine oil of viscosity mentioned in the operation manual is used. Is the appropriate oil used? — Go to Step 9. Replace with the appropriate oil, and Go to Step 1. 9 Check the cooling fan for fault. Repair or replace the faulty part. Is the procedure completed? — Go to Step 10. — 10 Is the scan tool (KW communication) available? — Go to Step 11. Go to Step 16. 11 Perform “Injection Stop for Each Injector”. 1. Select the “Actuator test” from the scan tool menu. 2.

Select the “Injection stop at each injector” in the “Common rail system”. 3. Press the “OFF” soft key to stop the fuel injection in the cylinder one by one, and check the change in engine sound. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 12. Go to Step 13. 12 Replace the injector in the cylinder of which engine sound did not change when it is stopped. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 13. — 13 Check the engine compression pressure. Repair or replace the faulty part. Is the procedure completed? — Go to Step 14. —