hitachi — About wiring diagrams

Electronic control fuel injection system (Common rail type) 1E-577 DTC Flash code DTC description Item to be detected Preconditions when DTC is set DTC set condition Judgment Time Behavior when trouble occurs Diagnos is lamp Recovery from failure P0611 34 Charge circuit fault (bank 1) ECM charge circuit 1 fault (internal burnout, open circuit, etc.) • Main relay power supply voltage is 16V or more. When charge circuit bank 1 voltage inside ECM is low. Approx. 1.5 sec. Intensive engine vibration, rough idling, output lowering, blow up fault, engine stall are possible. Back-up:

Common 1 stop (#1, #2, #3 cylinders stopped) ON *2 P0612 Charge circuit fault (bank 2) ECM charge circuit 2 fault (internal burnout, open circuit, etc.) When charge circuit bank 2 voltage inside ECM is low. Approx. 1.5 sec. Intensive engine vibration, rough idling, output lowering, blow up fault, engine stall are possible. Back-up: Common 2 stop (#4, #5, #6 cylinders stopped) ON *2 P1113 295 Boost temperature sensor fault (high voltage fault) Short circuit in sensor or harness • Key switch input voltage is 16V or more. • Coolant temperature is 50°C (122°F) or more. • 3 (or 5) minutes have passed after engine starting • DTC P1634 is not detected.

Boost temperature sensor voltage is more than 4.94V. Approx. 4 sec. Operationality is not affected. Back-up: No back- up ON *2 P1261 158 Injection nozzle common 1 drive system fault Open/short circuit in injector common 1- side electrical wiring, EDU output part fault • Main relay power supply voltage is 16V or more. • 70 rpm or more • None of the following DTC sets are detected; DTC P0611, P1261 and P0201; DTC P0611, P1261 and P0202; DTC P0611, P1261 and P0203. No injector 1, 2, 3 monitor input signal exists. Approx. 3 sec. Intensive engine vibration, rough idling, output lowering, blow up fault Engine stall is possible. Back-up:

Common 1 stop (#1, #2, #3 cylinders stopped) ON *1 P1262 159 Injection nozzle common 2 drive system fault Open/short circuit in injector common 2- side electrical wiring, EDU output part fault • Main relay power supply voltage is 16V or more. • 70 rpm or more • None of the following DTC sets are detected; DTC P0612, P1262, and P0204; DTC P0612, P1262, and P0205; DTC P0612, P1262, and P0206. No injector 4, 5, 6 monitor input signal exists. Approx. 3 sec. Intensive engine vibration, rough idling, output lowering, blow up fault Engine stall is possible. Back-up: Common 2 stop (#4, #5, #6 cylinders stopped) ON *1