1E-578 Electronic control fuel injection system (Common rail type) *1, *2, *3: Refer to “About recovery from failure” in “List of diagnostic trouble code”. List of items displayed on scan tool DTC Flash code DTC description Item to be detected Preconditions when DTC is set DTC set condition Judgment Time Behavior when trouble occurs Diagnos is lamp Recovery from failure P1634 55 Voltage fault in 5-V power supply 4 Power supply wiring short to sensor, or breakage in element/ circuit for power supply regulation inside ECM. • DTC P1630 is not detected. • Key switch input power supply voltage is between 16 — 32 V. 5-V 4 power supply voltage is 5.5 V or more, or 4.5 V or less. Approx. 0.5 sec.
Operationality is affected. Back-up: Same to boost pressure sensor fault ON *2 U2104 84 CAN Bus fault CAN communicati on fault • Key switch input voltage is 12V or more. Bus-off is detected. At 3 sec. continuo usly Vary depending on setting. Back-up: Switched to drive control by accelerator sensor input voltage ON *3 U2106 85 CAN timeout fault CAN communicati on fault • DTC U2104 is not detected. • Key switch input voltage is 12V or more. CAN data reception does not complete at a set time. At 1 sec. continuo usly Vary depending on setting. Back-up:
Switched to drive control by accelerator sensor input voltage ON *3 Display item Tech2 display item Engine torque — Actual engine speed Engine Speed Target engine speed Desired Idle Speed Glow signal Glow Relay Coolant temperature Engine Coolant Temperature Engine oil pressure Engine Oil Pressure Fuel flow — Barometric pressure Barometric Pressure Intake air temperature Intake Air Temperature Boost pressure MAP Sensor Boost temperature Boost Temperature Battery voltage Main Relay Voltage Cumulative used fuel amount —