1E-54 Electronic control fuel injection system (Common rail type) Step 15-4 To go to Step15-5, modify the Q adjust data within the set value and press the softkey “Program”. Step 16 When the writing of data completes, the following screen will appear. This indicates that the result of comparison of entered data with that written in the EEPROM of the ECM is in good condition. TSHK0102 Step 15-5 If the entered values meet the conditions in Step 15-1 and 15-3, the status display of data registration (writing) from the Tech2 to ECM as shown below will appear.
TSHK0104 Step 16-1 If the entered Q adjust data in Step 15-1 does not correspond to that written in the EEPROM of the ECM, the following message will appear. Pressing the softkey [End] returns you to Step 11. TSHK0103 TSHK0105