hitachi — Service Precautions

General Information 0A-5 Clean the connecting rod and bearing, and install the bearing to the rod. Cut the plastiguage to the same width as the crank pin, and while avoiding the oil pore of the crank pin lay the gauge parallel to the pin. Clean the clamp face of the cylinder block and crankcase bearing, and also the bearing, and install the cylinder block to the crankcase. Gently rest the crankshaft on the cylinder block, and rotate it approximately 30 degree to stabilize it. Cut the plastiguage to the same size as the journal width, and while avoiding the oil pore of the journal lay the gauge parallel to the journal.

Gently rest the crank case on the cylinder block, apply molybdenum disulphide to the thread section and bearing surface of the fastening bolt, and tighten in sequence to the correct torque. Line up the marks on the connecting rod and cap and install the crank pin, apply molybdenum disulphide to the thread section and bearing surface of the fastening bolt, and rotate both cap and bolt to the correct torque. Important: Do not move the connecting rod while using the plastiguage. Important: Do not rotate the crankshaft while using the plastiguage.

Gently remove the cap and connecting rod, and measure the crushed width of the plastiguage (clearance between rod and pin) using the scale printed on the bag. Gently remove the crankcase, and measure the crushed width of the plastiguage (clearance between bearing and journal) using the scale printed on the bag. Example: Measuring the clearance between the crank bearing and crank journal