hitachi — Service Precautions

0A-4 General Information Always use the liquid gasket products listed above, or a liquid gasket identical to the ones listed above. Use the correct quantity of liquid gasket. Always follow the handling instructions for each product. Application procedure 1. Wipe the contact surfaces clean of all water, fat or oil. The contact surfaces should be dry. 2. Apply a regular bead width of liquid gasket to one of the contact surfaces. Make sure that the bead does not break at this point. Notes: If there are special regulations concerning the application procedure in the repair document, please follow those regulations. Work procedure 1.

Wipe the joint surfaces of the bolt, bolt hole, and screw thread section clean of water, fat, and oil. The contact surfaces should be dry. 2. Apply Loctite to the top 1/3 of the screw. 3. Tighten the bolt to the correct tightening torque. Important: After tightening the bolt, do not apply excessive torque or try to rotate the bolt until at least one hour has passed, and the Loctite has hardened. Procedure for using the Plastiguage Example: Procedure for measuring the clearance between the connecting rod bearing and crank pin.

Seal section Product name Manufacturer's name Between gear case (block) – Cylinder block FMD–127 Loctite Between cylinder block and – Gear case and – Gear case FMD–127 Loctite Between idle gear A shaft and – Gear case FMD–127 Loctite Between cylinder block and – Flywheel housing FMD–127 Loctite Between cylinder block and – Flywheel housing and – Crankcase FMD–127 Loctite Between cylinder block and – Crank case FMD–127 Loctite Crankcase and – flywheel housing joint underside 1207B Three Bond Crankcase and – gear case joint underside 1207B Three Bond Cylinder head nozzle sleeve force fit and strike sections TL290 Loctite Cylinder block and – head cylinder cup section force fit section 1386 962T 123T Three Bond Loctite Nihon Hermetics Cylinder block, head plug nipple, unit, switches #271 Loctite O-ring omission prevention agent 1208 CH Dyne #290 Three Bond Cement dyne Type Measurable range (mm) PG-1 (Green) 0.025 – 0.076 PR-1 (Red) 0.051 – 0.152 PB-1 (Blue) 0.102 – 0.229