hitachi — Service Precautions

General Information 0A-3 8. Always check that there are no fuel leaks when performing maintenance work on the fuel system. (It may cause a fire.) Replacement parts and part numbers. 1. Always replace packing, oil seals, o-rings, caulking lock nuts, folding lock plates, split pins and other such parts with brand new parts. 2. The parts numbers contained in this manual may not represent the supply condition of the parts, and the part numbers may be changed due to revisions. Therefore, parts should always be checked against a parts catalogue before use. Liquid gasket 1.

Each time you disassemble parts that use liquid gasket, completely remove the old gasket residue from each of the parts and matching sections using a scraper, then clean each of the parts to completely remove oil, water, and dirt etc. from the various surfaces. Using the specified type of liquid gasket, apply new liquid gasket to each of the surfaces before reassembling the parts. 2. In order to make it easier to clean liquid gasket surfaces, apply gasket remover liquid (Pando- 391D made by Three Bond Co., Ltd.) and leave the part to stand for approximately 10 minutes, after which the old liquid gasket residue will be easier to remove.

However, this should not be used on resin components or painted components. 3. Please take care not to apply too much or too little liquid gasket. Also, you should always re-apply the liquid gasket upon itself when you start and finish application. 4. Make sure that there are no gaps when re- installing the liquid gasket parts to each other. If there are gaps between the two parts, re-apply the liquid gasket. Some parts, especially the oil pan, use the same size studs as a guide to eliminate the need for knock pin positioning etc. 5. Re-install these parts within 7 minutes of applying the liquid gasket. If more than 7 minutes passes, remove the previous liquid gasket and re-apply it. 6.

Please wait for at least 30 minutes since the last part is installed before starting the engine. 9. Pay close attention to the risk of ignition if you are handling parts that carry a high voltage. Furthermore, any oil or fat spilt onto rubber parts must be wiped off immediately, as it will cause deterioration of the rubber. Liquid gasket Seal section Product name Manufacturer's name Between head cover – Gear case – Cylinder head (Head upper side) 1207B Three Bond Between gear case – Cylinder head FMD–127 Loctite Between head cover – Gear case – Cylinder head (Head gasket upper side) 1207B Three Bond Between head cover and – Gear case – Cylinder block (Head gasket underside) 1207B Three Bond