hitachi — Functional check:

Engine Mechanical (6WG1 (Common rail)) 1B-7 Functional check: Compression pressure measurement Install a compression gauge Compression pressure measurement should be performed when the engine is cool (water temperature 20 ° C) and there are no abnormalities occuring with the battery or starter motor. Insert the compression gauge adapter into the glow plug installation opening and install the compression gauge. Special tools Remove the glow plugs Compression gauge adapter: 1-8531-7019-0 Compression gauge: 5-8840-2675-0 Remove all of the glow plugs.

Remove the injector and harness connector Compression pressure measurement Remove the injector harness connector from the lower head cover (no fuel injection). Turn the starter motor (200 rpm), and take the compression pressure measurement when the compression gauge needle has settled. Caution: Care must be taken as air is violently ejected from the glow openings while the engine is running. Measure the compression pressure for all cylinders. When the harness connector is removed, the ECU judges the removal as a failure and records an error code. Always clear the ECU memory after completing the compression pressure measurements.

(Refer to the troubleshooting manual for details on the ECU memory clear procedure)