hitachi — Functional check:

1B-8 Engine Mechanical (6WG1 (Common rail)) Notes: Some examples of the causes of engine noise can include the wear, burning, or overheating of each of the engine parts. Maintenance precautions 1. Most of the engine parts are still hot directly after operation, so make sure that the engine has cooled sufficiently before touching it. 2. When performing sensor inspection work, Diag- codes (Self-diagnostic codes) are recorded to the ECU memory. Using a scan tool, check the ECU for details of the Diag-codes. 3. Always take off the battery terminal to prevent damage or fire to electronic parts such as sensors etc. 4.

The injector harness and electromagnetic valve sections use a high voltage which may cause electric shocks. When performing maintenance work, always switch the starter switch to the Off position and remove the key. Valve clearance adjustment Valve clearance adjustment is split into 2 adjustments, setting to the number 1 cylinder compression top dead center and setting to the number 6 cylinder top dead center. Valve clearance adjustment Judging the correct timing for an overhaul Adjust to the number 1 cylinder (or number 6 cylinder) compression top dead center. Overhaul is required in the following cases Rotate the crankshaft forwards, and line up the flywheel T/C line and pointer.

At this point, check that there is a clearance (compression top dead center) between the number 1 cylinder (or the number 6 cylinder) locker arm and cam. Decline in compression pressure When the compression pressure is below 2260 kPa (23 kgf/cm 2 ) when measured using the measuring procedure shown in Compression pressure measurement. Rate of engine oil consumption increase Taking the consumption of a new engine as 100%, overhaul is required when oil consumption goes over 200%. Rate of fuel consumption increase Taking the fuel consumption of a new engine as 100%, overhaul is required when the fuel consumption goes over 140%.

Abnormal noises from inside the engine When abnormal noises from within the engine occur. Perform an overhaul as soon as possible and repair the fault. Item Compression pressure kPa/rpm {kgf/ cm2/rpm} Disparity between cylinders kPa/rpm {kgf/ cm2/rpm} Selection of a reference point 2750/ 200 {28 / 200} 196 {2.0} Limit 2260 / 200 {23 /200} –