Engine Mechanical (6WG1 (Common rail)) 1B-13 After completing the work above, remove the belt. 3. Remove the Starter motor. Legend 1. Flywheel housing 2. Nut 3. Starter motor Legend 1. V belt 2. Adjustment nut 3. Adjustment bolt (generator) 4. Bolt (generator) 5. Adjustment bolt (Idling pulley) Installation 2. Remove the generator. Remove the generator installation bolt, nut and adjustment nut, and remove the generator from the bracket. 1. Install the Starter motor. Install the starter cable to the lower section, and tighten it by nut to the starter and lower section. Tightening torque: 103 N m {10.5 kgf m} Legend 1. V belt 2. Adjustment nut 3. Adjustment bolt (generator) 4.
Bolt (generator) 5. Adjustment bolt (Idling pulley) Legend 1. Flywheel housing 2. Nut 3. Starter motor