1B-30 Engine Mechanical (6WG1 (Common rail)) 40. Remove the water outlet pipe. Fix the gasket into the installation flange side groove towards the cylinder block, and install the oil cooler. tightening torque: 50N m {5.1kgf m} Legend 1. Bolt 2. Water outlet pipe 3. Bolt 4. Bolt 5. Bolt Legend 1. Gasket 2. Oil cooler 3. O-ring Inspection EGR lead valve Check the outer appearance of the valve for damage. Inspect between the stopper and valve for carbon accumulation. Legend 1. Gasket 2. O-ring 3. Oil cooler 4. Water drain pipe 2. Install the water drain pipe and connector. Installation 1. Install the oil cooler. Insert 4 O-rings. (2 each of 2 types)