hitachi — Installation

Engine Mechanical (6WG1 (Common rail)) 1B-31 Temporarily install then fully tighten the connector (A), water drain pipe (B) and locking bolt (C) in this order. N m {kg m} A section: 78 {8.0} B section: 68 {6.9} C section: 43 {4.4} D Section: 4 {0.4} Tightening torque Legend 1. O-ring 2. Water pump 3. O-ring 4. Install the thermostat housing. Install the 2 thermostats to the oil cooler. For details on installing the seal ring and thermostat, please see the section on installing the thermostat. Fit gasket into the thermostat housing, and tighten the 2 water pump side bolts while holding the thermostat housing against the oil cooler side, then tighten the oil cooler side 3 bolts. Legend 1.

Connector (A section) 2. Water drain pipe (B section) 3. Water drain cock (D section) 4. Bolt (C section) 3. Install the water pump. Insert O-rings (2) into the water pump; hold the water pump against the gear case side while tightening the oil cooler side bolts (2), then tighten the 4 bolts from the gear case side. Tightening torque: 39 N m {4.0 kgf m} Tightening torque: 39 N m {4.0 kgf m}