hitachi — Installation

1B-36 Engine Mechanical (6WG1 (Common rail)) Clip the injection pipe in the positions shown in the installation diagram. When installing the injection pipes, install No3 and No4 first. Injection pipe tightening torque Sleeve nut: 39 N m {4.0 kgf m} Legend 1. Supply pump 2. Bracket 15. Install the common rail. Install the common rail installation bracket to the cylinder block. Install the common rail to the bracket. Tighten the fuel pump bracket at the same time. 17. Install the supply pump. Reverse the crank shaft one time to the before top dead center 90 ° position, next rotate it forwards and line up the flywheel carved line P- P mark and timing pointer line up.

At this time, check that the number one cylinder is near the compression top dead center. Tightening torque: 22 N m {2.2 kgf m} Notes: Tighten the bracket after installing the pipe clip. Legend 1. Bracket 2. Fuel pipe bracket 3. Fuel pipe bracket 4. Common rail Line up the supply pump mark. Install the supply pump bracket to the supply pump, and tighten it diagonally. Tightening torque: 31 N m {3.2 kgf m} 16. Install the injection pipes (1) ~ (6).