1E-60 Electronic control fuel injection system (Common rail type) Step 14 To register the ID code, press the softkey [Change]. The ID code for Cylinder1 (No. 1 cylinder) selected at Step 13 is shown here. 4. For VC17 (China), BCC code needs to be entered. NK3 request Tech2 calculates the entered data and displays the following message. • When entered ID code (QR) is out of the set value: Writing unable • When entered BCC code is out of the set value: Writing unable • When the ID code (QR) does not correspond to BCC code: Writing unable TSHK0073 Step 15 ID code registration (data entry) 1. The cursor is positioned at M (model code) in the default setting. MCD0 D1D2 2.
At this point, enter the model code (MC) and ID code (D0) in this order. Entering with the function keys (F0 F9) will automatically move the cursor to the right. However, if you enter with , (up/down) keys, you need to move the cursor with the arrow (left/right) keys. TSHK0074 3. Entered data must be within $00 $FF. You can enter 0 — 9 with the function keys (F0 F9), or 0 — Z with , (up/down) keys.