hitachi — Injector ID code (No. 1 cylinder - No. 6 cylinder) registration setting using Tech2

Electronic control fuel injection system (Common rail type) 1E-61 Step 15-1 1. The model code (MC) for VC25 is $5A, the Tech2 specifies to register (write) $5A automatically. However you may also enter. Tech2 calculates the BCC code (BC) and registers automatically. Therefore, you do not need to enter. 2. After entering the ID code input data byte (MC-D9), press [ENTER] key. Step 15-3 If you have entered incorrectly (D7:$EG), do the following. 1. After pressing [ENTER] key as with Step 15-1, press the softkey [Program]. This cause the error message “Invalid data Try again!” to appear. 2. Set the data entry limit judgment. Judgment condition: Data (1 byte) meets the following condition.

MSB:$F Data LSB:$F The following error message will be displayed until the value that meets the condition is entered. TSHK0075 Step 15-2 If the ID code you have entered is correct, press the softkey [Program]. If you want to quit the program (registration), press the softkey [Abort] or press [EXIT] key. Quitting the registration or pressing [EXIT] key returns you to Step 11. TSHK0077 Step 16 If the entered values meet the conditions in Step 15-1 and 15-3, the status display of data registration (writing) from the Tech2 to ECM as shown below will appear. TSHK0076 TSHK0078