Engine Mechanical (6WG1 (Common rail)) 1B-51 8. Remove the intake manifold. Shaft orientation clearances (mm) 9. Remove the exhaust pipe bracket. 10. Remove the engine carrier (Ft) bracket. 11. Remove the exhaust manifold ASM. Important: Do not re-use the locking nut. 5. Remove the O-ring for the gear case. 6. Remove idle gear shaft C. 7. Remove idle gear C. Extract the idle gear shaft, and remove idle gear C from the cylinder head. 12. Remove the seal ring for the exhaust manifold. 13. Remove the split collar. 14. Remove the spring sheet (upper). Place the cylinder head on a wooden board, use a compressor to remove the split collar, then remove the spring sheet, valve spring, and valve.
Important: Be careful not to damage the idle gear shaft bush. Notes: Install numbered tags to each valve cylinder. Compressor; Valve spring: 1-8523-5013-0 Standard Limit 0.05 ~ 0.14 0.25