hitachi — Disassembly

1B-52 Engine Mechanical (6WG1 (Common rail)) Legend 1. Bracket 2. Split collar 3. Bridge 21. Remove the valve seat insert. Use a gas welding burner to heat the 2 points on the inside of the insert until they are red hot (600~700 ° C), then leave to cool naturally for 3~5 minutes and extract with a screwdriver. 15. Remove the valve spring. 16. Remove the spring sheet (lower). 17. Remove the valve. 18. Remove the valve stem oil seal. 19. Remove the valve guide. Insert a replacer into the guide from the head underside, and hit it with a hammer. Important: Do not cool the hot points down too rapidly. Replacer; Valve guide: 9-8523-1202-0 22. Remove the nozzle sleeve.

Removing the nozzle sleeve Strike from the head lower side to extract. 20. Remove the bridge guide. Do not remove the bridge guide unless it is worn. Electrically weld (1) the bridge guide to the bolt, install a sliding hammer to the bolt and extract it.