Engine Mechanical (6WG1 (Common rail)) 1B-63 c. Assembling the cylinder head. Assemble the head gasket, line up the cylinder head with the knock pin, and gently put it down. d. Tightening the cylinder head ASM. Apply molybdenum disulphide to the M18 bolt screw section and bearing surface, and tighten as shown in the diagram spiralling out from the center. After that, tighten the M10 and M12 bolts. Tightening torque M18: 177 N m {18 kgf m} 245 N m {25.0 kgf m} angle 60 ~ 90 ° M10: 38 N m {4.0 kgf m} M12: 97 N m {9.9 kgf m} Important: Do not apply molybdenum disulphide to the M10 or M12 bolts. Use a rag etc. to cover the timing gear hole. The head bolts can be re-used up to 4 times. Legend 1.
M12 2. M10 3. Install the injector & clamp. Install the injector to the cylinder head, and temporarily tighten the injection pipe. Next, tighten the clamp using the clamp tightening bolt, and finally tighten the injection pipe. Notes: Securely install the gasket. Tightening torque Clamp: 49 N m {5.0 kgf m} Injection Pipe: 39 N m {4.0 kgf m} Important: Do not re-use the gasket.