hitachi — Installation

Engine Mechanical (6WG1 (Common rail)) 1B-65 c. Installing the camshaft Apply oil to the camshaft bracket. Set the camshaft so that the camshaft gear mark and pointer line up. At this time, check that the carved lines on the rear side of the camshaft are horizontal and vertical respectively. Legend 1. Pointer 2. Gear case (head) Legend 1. Eye mark 2. Cam gear 3. Lower cover (head) d. Installing the camshaft with the lower cover installed When assembling with the lower cover installed, set the camshaft so that one of the 2 camshaft gear eye-marks is hidden by the lower cover as shown in the diagram. e.

Installing the camshaft bracket Apply engine oil to the nut-bearing surface and screw section, line up the bracket marking number and install the bracket, temporarily tighten from the camshaft gear side then retighten to the standard torque. Notes: Be sure to install the No.1 camshaft bracket to the No.1 position. After installing the cylinder head bolt, tighten the bracket. Tightening torque: 76 N m {7.7 kgf m} Legend 1. Marking number 5. Install the bridge.