hitachi — Installation

1B-66 Engine Mechanical (6WG1 (Common rail)) Loosen the adjustment screw to the full limit, apply engine oil to the bridge guide and install the bridge. c. Valve clearance adjustment Refer to the adjustment outline that can be found in the valve clearance adjustment item in the functional check section. 7. Install the head lower cover gasket to the head lower cover. 8. Install the head lower cover. a. Clean the upper surface of the cylinder head, and apply liquid gasket to the upper surface of the joint between the timing gear case and cylinder head. Apply approx. φ 4 bead width of Three Bond 1207B liquid gasket along the joint surface between the cylinder head and gear case (head).

Install the head lower cover immediately after applying the liquid gasket. Assemble the head lower cover within 15 minutes of applying the liquid gasket. If the parts are left for more than 15 minutes, remove all of the liquid gasket, re-apply the liquid gasket, then assemble the head lower cover. If you have removed the head lower cover, remove the old liquid gasket while taking care not to allow any to go into the gear case, then reapply liquid gasket and assemble the parts. Notes: Assemble the parts to exactly the same cylinder number that you recorded when you disassembled them. Install the adjustment screws so that they face the intake manifold side. 6. Install the rocker arm ASM. a.

Loosen the adjustment screw to the full limit, apply engine oil to the roller section and adjustment screw tip section, and install the rocker arm ASM. b. After temporarily tightening in the number order shown in the diagram, tighten and fix to the standard torque in the number order shown in the diagram. Tightening torque: 90 N m {9.2 kgf m}