1B-68 Engine Mechanical (6WG1 (Common rail)) a. insert the injector side connector to the connector installed to the lower cover until you hear a click sound, then install the injector harness to the lower cover. Tightening torque: 22 N m {2.2 kgf m} Legend 1. Injector harness 2. Injector 12. Install the head cover gasket. 13. Install the head cover. a. Insert the gasket into the head cover and install the head cover. b. Tighten in the number order shown in the diagram. Legend 1. Nut 2. Connector b. Insert the harness (1) terminal into the head of each cylinder injector (2), then tighten the nut to the correct torque. Tightening torque: 15 N m {1.5 kgf m} Tightening torque:
2.0 N m {0.2 kgf m} Caution: Tightening the nut too much will cause damage to the injector, therefore it should never be tightened too much.