hitachi — Inspection

1B-76 Engine Mechanical (6WG1 (Common rail)) Journal diameter (mm) Work out the cam shaft journal external diameter by measuring each of the 4 points shown on the diagram with a micrometer. Clearance between camshaft journal and camshaft bracket (mm) Measure the clearance between the camshaft journal and camshaft bracket. Measure the inner diameter of the camshaft bracket, and outer diameter of the camshaft, and calculate the clearance. Clean the cam shaft bracket, check the markings on the side surface and assemble, apply engine oil to the screw section and tighten to the correct tightening torque.

Next, install the rocker arm shaft, apply oil to the screw section and tighten to the correct tightening torque. Measure each of the 4 positions in the diagram with a cylinder gauge and calculate the camshaft bracket's bore diameter. *Refer to the general remarks section when using a plastiguage to measure the clearance. Caution: Be sure to install the No.1 camshaft bracket to the No.1 position. The marking on the side of the camshaft bracket is not the journal number. Tightening torque Camshaft bracket: 75.5 N m {7.7 kgf m} Rocker arm shaft: 90.0 N m {9.2 kgf m} Nominal dimension Limit φ40.0 φ39.89 Standard Limit 0.065 ~ 0.125 0.15