hitachi — Installation

1B-84 Engine Mechanical (6WG1 (Common rail)) Important: Press the gasket securely into the slot and over all protruding sections. Tightening torque M10: 43 N m {4.4 kgf m} M8: 26 N m {2.6 kgf m} 6. Install the O-ring to the oil pump. 7. Line up the oil pump with the dowel position and install it. Notes: Do not mistakenly tighten the yellow painted bolt in the head section to the tightening torque shown above. This bolt is only for installing the oil pump cover. Tightening torque: 49 N m {5.0 kgf m} 10. Install the oil seal (crankshaft Ft) to the gear case cover. Important: When replacing the slinger and oil seal, always replace as a pair.

Take care not to damage the oil seal lip section and slinger 4-section screw machining surface. 8. Install the gasket and gear case cover together. 9. Install the gear case harness. Apply Loctite No.FMD127 liquid gasket to the idle gear A spindle bearing surface and distance bolt bearing surface, and promptly install them both. Apply Loctite No.FMD127 to the arrow diagonal section .