hitachi — Installation

Engine Mechanical (6WG1 (Common rail)) 1B-83 a. Set the number 1 cylinder compression top dead center. Rotate the crankshaft forwards, and line up the flywheel T/C mark to the pointer. At this time, check that the carved lines on the coupling and pump roughly line up. 2. Install the cover. 3. Install idle gear B. Apply engine oil to idle gear B bore and thrust sections, check the front/back markings that you made when disassembling the idle gear B and thrust plate, and install them. b. Apply engine oil to timing gear A bore, line up the timing marks for each gear, then assemble timing gear A, spindle, and thrust plate. Notes:

If you have temporarily installed the bolts, do not forget to remove them when installing the idle gear. Tightening torque: 108 N m {11.0 kgf m} Tightening torque: 46 N m {4.7 kgf m} 5. Install the distance bolt. Install 3 distance bolts to the positions shown in the diagram. 4. Install idle gear A. Tightening torque: 43 N m {4.4 kgf m}