1B-82 Engine Mechanical (6WG1 (Common rail)) 2. Inspect the crankshaft damper for cracks. a. Apply approx. 0.3mm thickness, approx. 4mm width of Loctite No.FMD127 liquid gasket to the installation surface. Also apply liquid gasket to the cylinder block and crank case match surfaces. Notes: Make sure that no liquid gasket gets into the bolt holes. Install the parts promptly after applying the liquid gasket. Assembly 1. Install the crankshaft damper to the crank pulley. Tighten the bolts in order in a diagonal line. Caution: Install the crankshaft damper so that the side with the caution label faces forward. Make sure that the crankshaft damper does not come into contact with oil or fat. b.
Install the timing gear case. Tightening torque: 118 N m {12.0 kgf m} Tightening torque M14: 135 N m {13.8 kgf m} M10: 43 N m {4.4 kgf m} Important: To re-use the installation bolts in the arrow section, apply Loctite 271 to the screw section. After installing the timing gear case, if there will be an interval of more than 30 minutes until the idle gear A and B installation work, temporarily install M10 Ч 1.5 bolts at the correct torque to sections 1~3 in the diagram. Installation 1. Install the timing gear case.