Engine Mechanical (6WG1 (Common rail)) 1B-89 Removal 1. Remove the NE sensor. 7. Use a slinger remover to remove the slinger. Legend 1. NE sensor 2. Flywheel housing Important: When replacing the oil seal, always replace the slinger together as a set. Remover; Slinger: 1-8521-0027-0 2. Remove the washer. 3. Remove the flywheel. 4. Remove the flywheel housing stay. 5. Remove the flywheel housing. 6. Remove the oil seal. Be careful not to damage or scratch the force-fit surface of the fly wheel housing's oil seal when removing the oil seal. Important: When replacing the oil seal, always replace the slinger together as a set. Notes:
If the remover separates easily from the slinger, tightening the jig's perimeter with a clip band to makes it easier to remove the slinger. Disassembly Flywheel 1. Remove the flywheel starter gear. Inspect the flywheel starter gear for damage. If there are no problems with it, do not remove it. Removing the flywheel starter gear Rest the flywheel on a wooden block, put a hit- stick on the flywheel starter gear and strike it to remove it.