hitachi — Installation

1B-90 Engine Mechanical (6WG1 (Common rail)) Inspection Flywheel Installation 1. Install the flywheel housing. After applying approx. 0.3 mm thickness and approx. 4 mm width of Loctite No.FMD127 liquid gasket, promptly install the flywheel housing. Inspect the flywheel for cracks or scratches, and replace if either is found. Flywheel starter gear Inspect the flywheel starter gear for damage. If there are no problems with it, do not remove it. Tightening torque M14: 123 N m {12.5 kgf m} M8: 22 N m {2.2 kgf m} Assembly 1. Assemble the flywheel.

Use a gas burner to uniformly heat the flywheel starter gear (less than 200 ° C), and install to the flywheel, with the gear that has the largest bevelling to the nearside. Notes: Tighten the bolt next to the knock pin first. Important: Also apply ample liquid gasket to the joint between the cylinder block and crankcase. Make sure that no liquid gasket gets into the bolt holes.