hitachi — Installation

Engine Mechanical (6WG1 (Common rail)) 1B-91 2. Install the flywheel housing stay. Tightening torque: 109 ~ 163 N m {11.1 ~ 16.6 kgf m} a. Apply a thin later of engine oil to the inner periphery of the oil seal. b. Use a installer and install the oil seal and slinger simultaneously. c. Tighten the center bolt until the sleeve touches the adapter. Legend 1. Cylinder block 2. Bolt (cylinder block side) 3. Bolt (flywheel housing side) 4. Flywheel housing Installer; Oil seal: 1-8522-0043-0 3. Install the oil seal. Notes: The installation position for the oil seal is set and classified by color. Engine front side …black purple Engine rear side ………

gray Check that the felt dust lip is being held inside the outward section of the slinger. Important: When replacing the slinger and oil seal, always replace as a pair. Take care not to damage the oil seal lip section and slinger 4-section screw machining surface. If there is damage or scratches on the axel section after extracting the slinger, apply liquid gasket (Loctite FDM127) in the limits shown in the diagram to the inner circumference surface of the slinger before re-installation.