1B-92 Engine Mechanical (6WG1 (Common rail)) 6. Install the NE sensor to the flywheel housing. Important: Always install the sensor after assembling the flywheel, not before. Legend 1. Crankshaft 2. Basic dimensions 3. Special tool (adapter) 4. Special tool (sleeve) 5. Location of special tool after press fitting 6. Location of special tool before press fitting 7. Oil seal 8. Slinger d. After pressing the parts in, wipe clean any traces of remaining oil. e. After installing the oil seal, measure the size (2) from the tip of the crankshaft to the oil seal surface. Basic dimensions: 7.0 ± 0.3 mm 4. Install the flywheel. 5. Install the washer and tighten the bolts.
Apply molybdenum disulphide to the bolt screw section and bearing surface, and tighten in the numbered order shown in the diagram. Tightening torque: 79 N m {8.1 kgf m} angle method 60 ° 30 °