hitachi — Installation

1B-104 Engine Mechanical (6WG1 (Common rail)) Important: Make sure that the piston and the connecting rod front mark are in the same direction. Install the setting tool to the cylinder block when using it. The piston ring will become damaged if the setting tool is not installed. Be careful not to damage the crank pin and oil when installing the piston connecting rod. Setting tool; Piston: 1-8522-0059-0 c. Avoid making the piston ring mitre direction the same as the side pressure direction, and divide into 4. Notes: Set the oil ring joint to the opposite side to the expander ring joint. 3. Install the connecting rod cap and bearing.

Install the bolts so that the arrows on the connecting bolt tip are in the direction shown in the diagram. Match the connecting rod cylinder number and cap cylinder number, apply molybdenum disulphide to the nut screw section and bearing surface, alternately tighten the nuts. At this time, check that the connecting rod cylinder number and cap cylinder number are facing to the right of the cylinder block. Tightening torque: 98 N m {10.0 kgf m} angle method 30 °→ 30 ° d. Apply oil to the piston and entire ring periphery. e. Check the cylinder number of the connecting rod, point the piston head arrow mark in the cylinder block front direction, and insert the piston by hand.

At this time, rotate the piston 5 ~10 degree to the right and insert, and return to the correct direction when in a position that no longer interferes with the oil jet. f. Use a setting tool, and insert the piston until it touches the crank pin using the handle of a hammer. Also, rotate the crank shaft while inserting the piston head, and set to the bottom dead center position.