Engine Mechanical (6WG1 (Common rail)) 1B-103 Legend 1. Top ring 2. Second ring 3. Third ring 4. Oil ring 2. Insert the piston and connecting rod into the cylinder. a. Apply engine oil to the full outer circumference of the cylinder liner (1). 6. Install the connecting rod bearing to the connecting rod. Installation 1. Install the connecting rod bearing to the connecting rod. Thoroughly clean the cap and connecting rod bearing installation surface and install the bearing, then apply engine oil to the sliding surfaces. Apply oil to the piston pin. Important: The connecting rod side bearings have slits and oil pores on each section.
The cap side bearing has oil slits on all peripheries but no oil hole. b. Rotate the crankshaft, insert the piston, and set the cylinder crank pin to the top dead center. Notes: Stopper the liner so that it does not get extracted.