1B-102 Engine Mechanical (6WG1 (Common rail)) Line up the piston head arrow mark and connecting rod front mark as shown in the diagram (same direction) and assemble. Next, apply engine oil to the piston pin and insert it. Each top ring, second ring and third ring is identified by the markings on the joining section side face. Install the piston rings so that each joining section is 90 ° apart. Take care not to remove any of the coating from the piston card section. Legend 1. Front mark 2. Grade section 3. Front mark 4. Fix the piston pin firmly with a snap ring. Finally, check that the piston and connecting rod can move smoothly. 5. Install the piston ring.
Installing the expander ring Insert the expander ring so there is no clearance in the ring mitre, and insert into the piston slot. There is no distinction between the upper and lower oil rings, but the expander ring should be installed so that the joining section is 180 degree reverse. Apply engine oil to the whole periphery of each ring and rotate the rings. At this time, check that the rings rotate smoothly and do not catch. Setting tool; Piston ring: 1-8522-1025-0 Installing the piston ring Put the joining section identification color of the top ring, second ring, and third ring to the right, and use a setting tool to Install them.
Identification Vertical Top ring Red paint (1) No markings Second ring Blue paint (2) 2 N Third ring Green paint (3) 3 N