hitachi — Disassembly

Engine Mechanical (6WG1 (Common rail)) 1B-109 Loosen and remove the bearing installation bolt from the outside. Next, extract the crank case installation bolt, screw in a M10 Ч 1.5 bolt with a neck lower length longer than 105mm into the crankcase replacer hole (arrow in the diagram), raise the crankcase, lift it horizontally and remove it. 4. Remove the thrust bearing. Use a label or other such marker to mark the thrust bearing's installation position. Disassembly 1. Use a gear remover to remove the crankshaft gear. Remover; Crankshaft gear: 1-8521-0064-0 Remover; Slinger: 1-8521-0027-0 Notes: Inspect the gears for damage. If there are no problems with it, do not remove it.

If a slinger is installed, remove the slinger first. 2. Remove the crankshaft. 3. Remove the crankshaft bearing. Use a label or other such marker to mark the bearing's installation position. Important: Do not damage or scratch the crankshaft bearing sliding surface.