1B-110 Engine Mechanical (6WG1 (Common rail)) Inspection Crankshaft Inspect the crankshaft for cracks and the bearing contact surface for damage. Perform magnetic flux method or red check method inspections whenever necessary. Crankshaft runout measurement Preserve the No.1 journal and No.7 journal using a crankshaft aligner or V block. Place a dial gauge on the crankshaft No.4 journal and gently rotate the crankshaft once to measure the amount of crankshaft runout. Crank journal and pin wear measurement Measure each of the 4 points shown on the diagram. Amount of crankshaft runout Limit: 0.15 mm Important: Do not modify the crankshaft as it has been treated with soft-nitrating treatment.
Bearing Inspect for wear, damage, scratches, de-bonding etc. Install the bearing and check that there is tension. Nominal dimension mm Standard mm Journal diameter φ105 No.4 φ104.850 ~ φ104.875 Others φ104.880 ~ φ104.905 Pin outer diameter φ92 φ91.895 ~ φ91.925