1B-114 Engine Mechanical (6WG1 (Common rail)) Apply oil to the engine oil slit side of the thrust bearing, and with the oil slit facing the outside, push it in to both sides of the cylinder block No.1 journal by hand. Apply approx. 4 mm width and more than 0.3 mm thickness of Loctite FMD-127 liquid gasket to the points on the underside of the cylinder block shown in the diagram (1,2,3,4,5,6) and install promptly. Legend 1. Knock pin hole alignment 2. Oil slit 3. Oil application Apply molybdenum disulphide to the M18 bolt screw section and bearing surface, and tighten in the numbered order shown in the diagram.
Also, apply oil to the M12 bolt screw section and bearing surface, and tighten the bolts. Apply engine oil to the thrust bearing oil slit (1) side. With the oil slit facing the outside, line up and install to the crankcase outward section. Notes: Check that the thrust bearing is securely installed. Check that the crankshaft rotates smoothly. Tightening torque N m {kg m} M18: 49 {5} 88 {9.0} Angle method 90 ° ~ 120 ° M12: 96{9.8} M18: Molybdenum disulphide application M12: Engine oil application 4. Install the crankcase.