Engine Mechanical (6WG1 (Common rail)) 1B-113 Check the installation position from when it was disassembled, and thoroughly clean the bearing and bearing installation surface, then install the bearing. Important: The cylinder block side bearings have slits and oil pores on all peripheries. The crankcase side bearing doesn't have slits or oil pores. Assembly 1. Install the crankshaft gear. Install the crankshaft and knock pin.
Warm the gears using an oil heater (oil temperature 170 ° C ~ 180 ° C) Next, point the gear's timing alignment mark “0” to the near side, line up the gear's key slot to the crank knock pin, and use a installer to insert until it contacts with the crankshaft collar section. 2. Install the crankshaft. Apply engine oil to the bearing's sliding parts surface, level the crankshaft and rest it on the bearings. Notes: Pay attention to the direction of the gears when installing. Installer; Crankshaft gear: 1-8522-0045-0 3. Install the thrust bearing. Installation 1. Install the crankshaft bearing.