1B-118 Engine Mechanical (6WG1 (Common rail)) Cylinder liner grade selection Match the cylinder block bore diameter (1) and liner diameter grade. Using the number written on the right side surface of the cylinder block, select a 1x for 1 or 2, or a 3x for 3 liner and install it. Important: If you do not select the correct grade of liner when installing new liner, it can cause a lack of coolant (large clearance), liner insertion difficulties (small clearance) and distortion. 2. Install the cylinder liner. Installing the cylinder liner Apply engine oil to the outer surface of the cylinder liner, and install straight along the cylinder block. Important:
When inserting the liner, do not strike or apply too much force. After inserting the liner, make sure that the liner does not come out when reversing the cylinder block. Cylinder block and liner combination Clearance between cylinder block and liner Selection of a reference point: 0.001 ~ 0.030mm Cylinder block and liner cleaning Adequately clean the cylinder block and liner, and after cleaning thoroughly wipe off all traces of cleaning fluid. Notes: The liner is very thin and should be handled with care. Arrow liner outer diameter grade marking position. Measuring the amount of cylinder liner projection Use a dial gauge to measure the amount of liner that is protruding.
Amount of cylinder liner projection Standard: 0.05 ~ 0.09mm Difference to adjoining cylinder Standard: Less that 0.025mm Block inscribed number Liner grade 1 ⋅2 1x 3 3x