hitachi — Assembly

Engine Mechanical (6WG1 (Common rail)) 1B-117 Cylinder liner inner diameter Oil jet Inspect the oil pore of the oil jet and joint bolt. When re-using the liner, clean off any carbon from the liner upper section using a scraper or other such tool. Important: It is not possible to repair liner boring or honing. Prevent the liner from being extracted. Cylinder block Inspection for blockage or corrosion of the coolant and oil lines Carefully inspect between each of the cylinders for blockages in the coolant lines. Inspect the cylinder block for cracks or damage. Perform magnetic flux method or red check method inspections whenever necessary.

Inspection for water leakage from the water jacket Apply water pressure of 490 kPa {5 kgf/cm 2 } from a hydraulic test machine for 3 minutes, and inspect each cylinder block for water leaks. Inspection Crankcase Inspect the crankcase for cracks or damage. Perform magnetic flux method or red check method inspections whenever necessary. Assembly 1. Assemble the cylinder block. Nominal dimension mm Limit mm φ147 φ147.3