Cooling system (6WG1 (Common rail)) 1C-13 Use a press from the gear side and extract the shaft. 4. Remove the rear cover. 5. Remove the bearing (small). 6. Remove the gear. 7. Remove the bearing (large). 8. Remove the shaft. Use a press and extract the shaft with bearing installed from the impeller side. Legend 1. Bearing 2. Gear 9. Remove the oil seal (2). 10. Remove the seal unit (1). Remove the oil seal (2) while being careful not to damage the force fit section. Also, remove the seal unit (1) while being careful not to damage the force fit section. Legend 1. Seal unit 2. Oil seal