Cooling system (6WG1 (Common rail)) 1C-15 5. Install the shaft ASM. Use a press to push the shaft ASM into the water pump body. 7. Install the bearing (small). 8. Install the rear cover. Apply piping etc. to the bearing's outer lace, and press it in while taking care not to damage the rear cover. Important: Be careful not to damage the oil seal. 9. Install the rear cover ASM. Using a press, apply piping etc. to the bearing (small) inner lace and press it into the shaft. At this time, line up the bolt Installation positions on the rear cover. 6. Install the gear.
Using a press, face the large side of the projecting center boss section towards the seal unit side, and push in until it contacts with the bearing. Tightening torque: 27 N m {2.8 kgf m} Notes: To prevent damage to the bearing, press it in while it contacts with the impeller insertion side shaft edge. Notes: To prevent damage to the bearing and rear cover, press the ASM cover in while it contacts with the impeller insertion side shaft edge.