hitachi — Disassembly

1E-10 Electric system (6WG1 (Common rail)) Disassembly Notes: Before disassembling the starter, install temporary markers to the magnet switch, yoke, front bracket and rear bracket to make it easier to reassemble them. First, remove the pinion. If you proceed with the disassembly without removing the pinion first, the method for removing the pinion will be lost, and you will be unable to disassemble the starter. However, the motor section and magnet switch can be removed without first removing the pinion. 1. Remove the snap ring. 2. Remove the stop ring. 3. Remove the pinion.

Under normal circumstances, if the pinion or stop ring is hit towards the front bracket side, the front bracket will break. Hit the stop ring when the pinion is out in the cranking position. Connect the starter to the battery as shown in the diagram. When switch SW1 and SW2 are closed, the pinion advances to the cranking position and the armature rotates. Then open switch SW2 to stop the armature from rotating. Select a pipe that is a perfect fit size to the stop ring and put it against the stop ring, hit the pipe with a hammer and remove the stop ring to the pinion side one time. Next, remove the snap ring, stop ring, pinion, and pinion spring. Important: Do not re-use the snap ring.

Important: Remove the pinion within 10 seconds because it will generate heat if the electric current is left on. Legend 1. Pinion 2. Crankshaft 3. Snap ring 4. Stop ring 5. Pipe 6. Pinion spring Legend 1. Snap ring 2. Stop ring 3. Pinion gear 4. Remove the pinion spring. 5. Remove the screw. 6. Remove the magnet switch.