hitachi — Disassembly

Electric system (6WG1 (Common rail)) 1E-11 Remove the magnetic switch's M terminal nut, and remove the lead wire with the terminal installed. Next, remove the magnetic switch Installation screw and remove the magnetic switch. Notes: The Installation screw is very tight, so an impact driver should be used to loosen it. Legend 1. Armature 2. Through bolt 3. Rear bracket 4. Brush holder 5. Yoke ASM 15. Remove the plate. 16. Remove the gasket. 17. Remove the planet gear. Remove the four planetary gears. Pull the internal gear, gear shaft, overrunning clutch and lever out of the front bracket together as one. 7. Remove the screw. 8. Remove the through bolt.

Remove the brush holder Installation screw and through bolt. Next, remove the rear bracket. At the same time, remove the O-ring. Important: Do not re-use the O-ring. 9. Remove the rear bracket. 10. Remove the yoke ASM. 11. Remove the O-ring. Place a socket (outer diameter 38mm) against the armature commutator. Next, allow the brush to slide on the top of the socket, and with the brush rested on the socket, remove the yoke ASM. Remove the O-ring at the same time. 12. Remove the brush holder. Pull the brush spring upwards, and remove the brush from the brush holder. Next, remove the brush holder. 13. Remove the armature. 14. Remove the ball. Remove the armature.

The ball also comes out at the same time, but sometimes it becomes stuck in grease and doesn't come out. The bearing can be removed using a common puller. Legend 1. Overrunning clutch 2. Lever 3. Internal gear 4. Gear shaft 5. Planetary gear 18. Remove the lever.