hitachi — Inspection

1E-12 Electric system (6WG1 (Common rail)) Notes: Remember the direction of the lever. Earth inspection The armature coil earth (bad insulation) is inspected using a circuit tester. If the armature is grounded it must be replaced. 19. Remove the E shape retaining ring. Remove the 2 E shape-retaining rings. Turn the spline for just 1 gear tooth amount, and remove the overrunning clutch from the gear shaft ASM. Important: Do not re-use the E shaft retaining ring after it has been removed. 20. Remove the overrunning clutch. 21. Remove the internal gear. 22. Remove the washer. Detach the internal gear. At this time, take out the washer that adjusts the gear shaft direction play. 23.

Remove the gear shaft. 24. Remove the front bracket. 25. Remove the bearing (component parts table 20). 26. Remove the brush. 27. Remove the bearing (component parts table 7). Commutator inspection Inspect the outer periphery of the commutator for wear. If the commutator is worn beyond the limit, it must be replaced. Inspection 1. Armature Growler test Internal short circuits in the armature coil are inspected using the growler test. If a short circuit is detected, replace the armature.