Electric system (6WG1 (Common rail)) 1E-13 Inspect the depth of the commutator insulation mold (undercut). Remove dirt and powder etc. caused by wear from the brushes, and repair if there are any faults. Earth inspection Use a circuit tester to inspect the coil earth (bad insulation). If the coil is earthed, either repair it or replace the yoke ASM. Gear inspection Inspect the gear section for wear or damage. If a fault is detected, replace the armature. 3. Brush Inspect the brush length for wear. If the brushes are close to the wearing limit, replace the entire brush holder ASM to replace the brush holder side brushes.
To replace the yoke ASM side brushes, you can replace just the brushes only. Check that the brushes move smoothly in the brush holder. Also inspect the pressure of the brush spring. Use a circuit tester to inspect the brush holder earth (bad insulation). The brush holder should be cleaned before inspection. Place one of the circuit tester probes on the brush holder plate (metal part) and the other probe on the insulated holder. The presence of conduction indicates bad insulation, so the brush holder ASM must be replaced. Bearing inspection Inspect the bearings for abnormal noise, looseness, and leaking grease. If a fault is detected, replace the bearing. 2.
Field coil Conduction inspection Use a circuit tester to inspect the coil for broken wires. If the broken wire is detected the yoke ASM must be replaced.