hitachi — Inspection

1E-14 Electric system (6WG1 (Common rail)) 5. Front bracket Inspect the bearing and oil seal, and replace the front bracket ASM (including the bearing and oil seal) if a fault is discovered. 6. Internal gear and planetary gear Inspect the gear teeth, and replace the internal gear or planetary gear if there is any abnormal wear or damage. 7. Lever If parts that rub against the overrunning clutch become worn, the pinion's pulled out position will be upset. Refer to the re-assembly section for details on adjustments to the pinion's pulled out position. 4.

Overrunning clutch and pinion Overrunning clutch inspection Hold the overrunning clutch housing with one hand and rotate the pinion with the other hand. In one direction, the pinion should gently rotate with a certain amount of resistance, but it should not rotate at all in the opposite direction. If this is not the case, the overrunning clutch must be replaced. Inspect the pinion, and replace it if there is any wear or damage. Notes: The overrunning clutch interior is filled with grease. If you wash the overrunning clutch with oil remover of detergents that remove oil, the grease may be washed out of the overrunning clutch.

Therefore, the overrunning clutch should only be cleaned with a cloth.