hitachi — Assembly

1E-16 Electric system (6WG1 (Common rail)) Assembly E shape retaining ring O-ring (gasket on both ends of the yoke, and each screw section) Re-assembly can be done in the opposite order to disassembly, but the following cautions must be followed. 1. The parts that require oiling are as follows. The following brands of grease are recommended: MULTEMP 0A-171 (Kyodo Yushi Co., Ltd.) for 1,2,3,4,5,6 on the diagram, and Moricote R AG650 (Dow Corning) for 7,8,9 on the diagram. Notes: The following parts should be replaced with brand new parts. Snap ring (fixing the stop ring) Legend 1. Armature bearing outer periphery surface (very little) 2. Plunger (very little) 3.

Gear shaft spline section and slide section 4. Clutch shaft slide section 5. Oil seal 6. Under the pinion 7. Lever and overrunning clutch sliding parts 8. Sleeve bearing and ball 9. Armature shaft gear, planetary gear, internal gear 2. Tightening torque See the correct torque specifications for the correct tightening torques. 3. Armature shaft direction play No need for adjustment. Insert the ball into the shaft tip section. 4. Gear shaft direction play By inserting one washer between the internal gear and gear shaft, the required gap is automatically preserved. Pass the washer, internal gear and overrunning clutch through the gear shaft.

Next, move the overrunning clutch 1 spline tooth amount and check that the overrunning clutch does not slip out, then install the E shape retaining ring.