Electric system (6WG1 (Common rail)) 1E-17 6. Pinion's pulled out position inspection After installing the starter, inspect the pinion's pulled out position. Measurement and inspection procedures should be carried out as follows. Connect the starter to the battery as shown in the diagram. When switch SW1 and SW2 are closed, the pinion advances to the cranking position and the armature rotates. Then open switch SW2 to stop the armature from rotating. Legend 1. Overrunning Clutch 2. Internal gear 3. Washer 4. E shape retaining ring 5. Gear shaft 5. Installing the pinion Install the pinion before installing the magnetic switch to the front bracket.
Install the pinion spring, pinion, and stop ring to the clutch shaft in order. Last, install the snap ring to the clutch shaft slot tightly. Next, pull the stop ring tightly onto the stop ring side with a gear puller, and fix them both. Gently press the tip of the crankshaft by hand (press and release) and measure the size of crankshaft movement (return movement). This value should be 0.5 ~ 2.0 mm. If the measured size is outside this limit, adjust the number (up to 2) of gaskets (thickness 0.5 mm) between the magnetic switch and front bracket, or replace the lever. Legend 1. Pinion 2. Crankshaft 3. Snap ring 4. Stop ring 5. Pinion spring 7. No-load test