hitachi — Disassembly

Electric system (6WG1 (Common rail)) 1E-29 Disassembly Only important points are described. Caution: In order to make the re-assembly easier, install identification marks to the front bracket and rear bracket before disassembly. 1. Front & rear bracket connection Remove the 4 through bolts, then insert the tip of a minus screwdriver between the stator and front bracket, and very carefully pry the front bracket from the rear bracket to separate them. Caution: Take care not to damage or scratch the stator coil. 3. Bearing related If you need to remove the front bearing, remove the retainer Installation screws, and press the bearing out using an appropriate socket.

If you need to remove the rotor bearing, a common bearing puller can be used to remove it. Caution: Only remove when it is completely necessary to do so. Do not re-use bearings that have been removed. 4. Coil ASM related To remove the coil ASM, you first need to remove screw A (which fixes the coil terminal section to the IC regulator). Removing screw B (which fixes the coil ASM to the bracket) before removing screw A can cause the terminal section to break. Support the coil ASM by hand to prevent damage to the terminal section. Next, remove screw B and remove the coil ASM. Legend 1. Pulley 2. Front bracket 3. Front bearing 4. Roller 5. Coil ASM 6. Stator 7. Rectifier 8. Rear bracket 2.

Rotor related Fix the rotor in place with a vice without deforming the rotor ball. Remove the pulley Installation nut, and remove the pulley, fan, clearancer and front bracket. Caution: Always clamp the (2) section in the vice when tightening the rotor. Do not clamp section (1) because it has weak reinforcement.